How do you make a circle fully defined in SolidWorks?

How do you define a circle completely?

The circle is fully defined because both its diameter and location are known. The location was fully defined when we located the circle’s center point on the origin.

How do you make something fully defined in SolidWorks?

To fully define a sketch:

  1. Edit a sketch.
  2. Click Fully Define Sketch. (Dimensions/Relations toolbar) or Tools > Dimensions > Fully Define Sketch.
  3. Set the options for relations and dimensions in the Fully Define Sketch PropertyManager.
  4. Click .

Why is my circle under defined SolidWorks?

The reason is because the sketch instances can rotate.

You could previously Fully Define the instances by adding a Horizontal or Vertical relation on one of the construction lines tied to the instances.

What is over defined in Solidworks?

Potential Reasons for These Error Messages

Dimensions or relations are in conflict or are redundant. When you insert dimensions, they are assumed to be driving dimensions. To have two dimensions driving the same geometry is invalid. Over Defined Dimension Example.

How can we confirm that a sketch is fully defined solidworks?

To identify which entities in your sketch are not fully-defined, look at the color of the curves:

  1. Blue indicates not fully-defined; you can drag to move the entity or change its size.
  2. Black indicates fully-defined; you cannot drag to move or alter the entity.
THIS IS SIGNIFICANT:  How do you use cosmetic thread in Solidworks?

Why isn’t my SolidWorks sketch fully defined?

In some sketches only certain relations and dimensions can fully define the sketch. Limiting your selection may prevent the sketch from being fully defined. In this sketch, no relations were allowed. It cannot be fully defined.

How do you constrain in SolidWorks?

To define assembly constraints:

  1. Under Tolerance Assembly, select a part to constrain in the simplified assembly. …
  2. Set the primary constraint by clicking 1 in the callout constraint of plane P6. …
  3. Set another constraint. …
  4. Set a tertiary constraint. …
  5. Click .