How do you make a 3D curve in Solidworks?
To project a curve: Click Project Curve on the Curves toolbar, or Insert > Curve > Projected. Use this selection to project a sketched curve onto a model face. Under Sketch to Project , select the curve in the graphics area or from the flyout FeatureManager design tree.
Can trapezoids be 3D?
The 3D figure of a trapezoid is called a trapezoidal prism since these are figures that have a length, width, and depth. The edges of the prism is where the faces meet, and the vertices of the prism are the corners where three or more surfaces meet.
How do you make a pyramid in Solidworks?
To create a pyramid:
- Click Solids > Draw > Pyramid (or type Pyramid).
- Specify the center point of the base or enter an option: Edge: Lets you define the edge of the pyramid base by specifying edge endpoints. …
- Specify the base radius or enter an option: …
- Specify the height or enter an option:
How do I convert entities in Solidworks?
To convert an entity:
- In an open sketch, click a model edge, loop, face, curve, external sketch contour, set of edges, or set of curves. You can also click an entity after clicking the Convert Entities. …
- Click Convert Entities. …
- In the PropertyManager, click Select chain to convert all contiguous sketch entities. …
- Click .
How do you make a trapezoid in SolidWorks?
To construct trapezoids:
- Type Trapezoid at the command prompt.
- In the graphics area, specify the midpoint of the first side.
- Specifiy the insertion angle of the trapezoid (the angle of the axis).
- Specify the length of the axis.
- Specify the height of the first base of the trapezid.
- Specify the height of the second base.